Blog

MF35 Still In Daily Farm Use

Want to check out our tractor maintenance videos? Click here to see what we've got!

Today we were dirilling fodder beet using our own 1962 Massey Ferguson 35. The tractor was bought brand new from ‘Claytons of Gilberdyke’ for £620 and was one of the first machines to have the differential lock fitted. Back in the 1960’s and 70’s it was the main tractor on the farm and undertook most […]

By |January 15th, 2009|Articles/News|Comments Off on MF35 Still In Daily Farm Use

MF35 (Perkins) Oil Pump And Filter 3A-152

The life of the oil pump can be extended by adhering to the recommended engine oil change frequency. The engine oil and filter should normally be changed every 200 hours. If the filter element becomes clogged before it is changed, then pressure will build up in the inlet port which will open the spring loaded […]

By |January 15th, 2009|Engines, MF35 FE35 TO35|Comments Off on MF35 (Perkins) Oil Pump And Filter 3A-152

MF35 Hydraulic Lift Not Working Properly

Hello,

I am having a problem with a Massey 35 4cyl. When I bought it I was told that the Hydraulic pump had been totally reconditioned, however the lift didnt work. I removed the lift cover and found that the hydraulic cylinder was cracked. I replaced it and the piston. I started the tractor with the […]

By |January 15th, 2009|Hydraulics, MF35 FE35 TO35|5 Comments

MF35 Engine Rebuild – Rebuilding

The engine block is now re-assembled. The clutch plate has been replaced, has been bolted back to the flywheel and set-up. The engine block and clutch has been re-attached to the back end and painted. All the tappets have been properly adjusted and the first stages of the timing operation have been performed.

 This final photograph […]

By |January 15th, 2009|MF35 FE35 TO35|1 Comment

MF35 Engine Rebuild – Strip Down

The engine rebuild got off to a brisk start with most of the ancillaries being removed in just a few hours and then the engine was hoisted off the bell housing successfully. That revealed that an incorrect clutch plate had been fitted previously. It was a flat plate, when a dished centre should have been […]

By |January 15th, 2009|MF35 FE35 TO35|8 Comments

MF35 Engine Rebuild – Assessment

The Massey Ferguson 35 engine itself was dismantled today. The cylinder head was removed before the engine was lifted from the rest of the tractor, and then the block and associated parts were lowered onto the bench with the engine hoist.

We found several problems which would need some attention. The hard facing on […]

By |January 15th, 2009|MF35 FE35 TO35|Comments Off on MF35 Engine Rebuild – Assessment

MF35 Engine Rebuild – Introduction

This week we have been asked to do an engine rebuild on a Massey Ferguson 35. It has the Standard Motor Company 23C 4 cylinder diesel engine fitted and the serial number puts the date of manufacture at 1959. This engine model is well known by enthusiasts to be difficult to start and this one […]

By |January 15th, 2009|MF35 FE35 TO35|1 Comment

MF35 Engine Rebuild – Fully Restored

All the ancilliaries have now been fixed back to the Standard 23C engine. A new battery and wiring loom have been fitted and painting has been ongoing as parts have been added. The front axle pivot has been re-bushed and all the fuel sytem piped up.

After bleeding the tractor’s fuel system […]

By |January 15th, 2009|MF35 FE35 TO35|Comments Off on MF35 Engine Rebuild – Fully Restored