Want to check out our tractor maintenance videos? Click here to see what we've got!
Hi,
I’ve got a MF35X which I have been using to “top” the reeds with a small topper. Unfortunately, the PTO has been slowing and even coming to a stop when under load, and the lifting hydraulics have failed several times when trying to lift the topper. Both functions appear to return once the load is decreased.
Do you think the two problems are linked? If so what is causing the problem, and finally, how do I fix it?
Many thanks in anticipation of your help.
Best wishes,
– Mike
Hi Michael,
Most of the 35X’s have a dual clutch. As you may know this means that when you press the clutch pedal half way down the drive to the gearbox is disengaged. When you depress the clutch pedal all the way to the bottom it disengages the drive to both the pto and the hydraulic pump (which means you can easily engage the pto).
Therefore, if your pto and hydraulics are slowing down when under load it will be this clutch which is slipping. The first thing to do is to remove the plate on the underneath side of the clutch housing. You will notice a hole in the bottom which has a split pin in it – this hole is designed to let any drips of oil out of the clutch housing which may have entered from either the crankcase or the gearbox. On occasions this hole becomes blocked and oil gets onto the clutch plates and makes them slip.
More likely is that your clutch will just need adjusting. All the instructions you need are on the clutch page.
Hopefully that will solve your problem. If the clutch still slips then you will need to split the tractor and replace the clutch.
Hope that helps. Let us know how you get on.
Regards,
Steve.
Hi Steve, took off inspection plate and out poured about three quarters of a pint of oil!! cleaned out inside of casing as best I could, and cleaned out the hole that the split pin sits in. Tried to adjust the PTO clutch, but locking nuts were on too tight. Decided to give it a go with the topper back on, and everything now seems to be working fine. Thank you very sincerely for your help, it really was invaluable.
Many thanks and best wishes – Mike
Glad you found the problem.
If your tractor is now working fine for light work then that is OK. The oil will have got onto both clutch plates (i.e. the one for the hydraulics/pto and also the clutch that operates the transmission drive. If you experience problems you may need to replace the clutch plates some time in the future.
[ad#2-ad-banner]
Do 35’s and 40’s have about the same clutch
what oil gose in massey ferguson 35 front loader
Hi John,
If there is a change in the way the system operates when it getw warm then I’m afraid it is likely to be a problem with the hydraulic system itself.
Basically when the oil gets warm it becomes less viscous (it becomes thinner) and hence more likely to leak past any components.
It is possible for the problem to be something simple such as an o’ring on the stand pipe, but a leaking o’ring may well also leak to quite an extent when the oil is cold.
It is more likely to be wear in either the hydraulic pump and/or control valve. It could be the relief valve or a problem with the cylinder, but usually the pump and control valve. A pump repair kit isn’t all that expensive and the DVD shows how to refurbish the pump correctly.
Got a MF 35X the lift arms are slow to lift to any height when it is cold they lift ok is this due to the oil needing change or oil on the dual clutch as you have menchand before ? Thanks John
mountbellew vintage club
how much is it 2 sandblast a fordson dexta.are they a easy tractor to restore david glennon galway
hi i have dexter tractor whene i ham toping the p.t.o keeps jumping out of gear why is this ian
Hi i recently bought a 35x but lift handles stuck wont move just wondering how to solve problem hope you can help. thanks again