Engines

/Engines

Ferguson FE35 Vaporising Oil, Correct Thermostat?

Want to check out our tractor maintenance videos? Click here to see what we've got!

I have a FE35 and am busy redoing the motor as it was spewing oil. Its a Vaporising oil motor, at least I think so because the carb has a 1578 stamped on it. Is there any other way of identifying the actual motor? I also see the only difference would be the S.R. Jet […]

By |January 15th, 2009|Engines, MF35 FE35 TO35|5 Comments

How Much Will It Cost To Rebuild My Tractor Engine

One of our customers who purchased an Engine Rebuild DVD was interested to know how much it would cost for the engine kit and to have the specialist work done at the engineers before he started – so here’s the answer.

Hi there,

Just watched your MF35 23C engine rebuild DVD (very, very good) . Id […]

By |January 15th, 2009|Engines|7 Comments

Ferguson TO35 23C Liner Replacement

One of our readers (Don) has sent in some info about his 1958 TO35. Don’s father bought the tractor back in 1964 and in 1978 (11,000 hours) the engine was pulled down for a rebuild. The crankshaft and bearings were all still good after these engine hours, but one of the liners was broken and […]

By |January 15th, 2009|Engines, MF35 FE35 TO35|1 Comment

FE35 Push Rod Lengths

stephen hibble wrote:

Hi hope you can help me,

I have just been given a massey fe 35 tractor my problem is the last owner started to rebuilt it but passed a way I have refitted the head but I am stummped with the push rods 6 are long, 2 are a bit shorter any hints of […]

By |January 15th, 2009|Engines, MF35 FE35 TO35|1 Comment

Assessing Cylinder Liners

The information in this article applies equally to plain bored blocks (eg. Ford) as it does to tractor engines with replaceable liners.

The continual friction between the piston rings and the piston liners (bores) eventually causes wear to the liners. Wear also occurs because of the slight lateral force exerted on the piston from the motion […]

By |January 15th, 2009|Engines|Comments Off on Assessing Cylinder Liners

Timing Tractor Injection Pump Using Spill Cut Off Point

Sometimes we want to know how to time the injection pump of a tractor engine when we have not got a manual to tell us how to do it. Fortunately there is another method called “spill cut off point timing” which we can use to time the injection pump. The procedure described below is for […]

By |January 15th, 2009|Engines|10 Comments

Smoking Engine Massey Ferguson 35

Hi was wondering if anybody could help me with a problem with a 23c Massey 35 I bought a few weeks ago. When i bought it i was told it had a full engine rebuild but was still very Smokey. Was told it would be the injectors so had them sent away and serviced , […]

By |January 15th, 2009|Engines, MF35 FE35 TO35|9 Comments

MF35 (Perkins) Oil Pump And Filter 3A-152

The life of the oil pump can be extended by adhering to the recommended engine oil change frequency. The engine oil and filter should normally be changed every 200 hours. If the filter element becomes clogged before it is changed, then pressure will build up in the inlet port which will open the spring loaded […]

By |January 15th, 2009|Engines, MF35 FE35 TO35|Comments Off on MF35 (Perkins) Oil Pump And Filter 3A-152